Classifications of TZM Hot Runner Gate
- Details
- Category: Molybdenum knowledge
- Published on 07 April 2015
- Written by limei
- Hits: 241
According to the position of the gate, TZM hot runner gate can generally be divided into the following three categories:
1. The outside of the center gate. Outside the central gate is the most widely used gate, spout gate of TZM hot runner mold usually be chose in a central location in the plastic parts of the sidewalls. When selecting in the design knowledge base, plastic parts, if not special needs, should be preferred in this gate.
2. The inside of the center gate. Inside of the center gate with those stringent requirements for appearance, and in the course can not be exposed to any traces of plastic on top of the gate.
3. The side gate. Some thin-walled plastic parts, in front of the center of the open gate affect the appearance and use, you will need to open the side gate. In order to increase the strength of TZM hot runner gate, the angle perpendicular to the side surface of the direct gating.
More molybdenum product: http://www.molybdenum.com.cn
Tel: 0592-5129696 Tax：0592-5129797
E-mail:
This email address is being protected from spambots. You need JavaScript enabled to view it.
Tungsten News & Tungsten Prices, 3G Version: http://3g.chinatungsten.com
Tungsten News & Tungsten Prices, WML Version: http://m.chinatungsten.com
sales@chinatungsten.com