Titanium Zirconium Molybdenum Hot Runner Injection
- Details
- Category: Molybdenum knowledge
- Published on 04 November 2015
- Written by yiping
- Hits: 379
Heating titanium zirconium molybdenum (TZM) hot runner to make sure plastic on the runner and sprue keep molten condition. Titanium zirconium molybdenum hot runner is an advanced casting injection system which is after injection only needs to take up the products but will not produce runner freezing material. Because runner’s nearby or central don’t have heating rod and heating ring so all the runner which is from injection molding machine nozzle to sprue are at high temperature making plastic keep molten and finish the operation don’t need to open the runner to remove the freezing material. And when operate next time only need to heat hot runner to the desired temperature.
Titanium zirconium molybdenum hot runner injection will produce little stress and even density products. Under little injection stress, at the short time, compared to other injection product TZM hot runner can produce better products. The advantages of TZM hot runner especially obvious in clear parts, thin parts, large plastic parts and high required plastic parts. What’s more, it can use the small machine to produce large products.
More molybdenum product: http://www.molybdenum.com.cn
Tel: 0592-5129696 Tax：0592-5129797
E-mail:
This email address is being protected from spambots. You need JavaScript enabled to view it.
Tungsten News & Tungsten Prices, 3G Version: http://3g.chinatungsten.com
Tungsten News & Tungsten Prices, WML Version: http://m.chinatungsten.com
sales@chinatungsten.com